Well I was about to propose you to use a TopoDS_Face as a profile, but it seems it's not supported. Maybe I'm wrong I need to have a closer look or someone confirm us it can't work.
By the way une can build 2 pipe surfaces and close the solid creating 2 flat faces using this exemple : http://neweopencascade.wordpress.com/2014/03/01/post1/
Wed, 03/26/2014 - 02:47
Hi you can have a look here :
[link=http://neweopencascade.wordpress.com/2014/03/25/building-a-pipe-elbow/ newwindow]http://neweopencascade.wordpress.com/2014/03/25/building-a-pipe-elbow/[/...
Wed, 03/26/2014 - 02:48
Sorry I'm not familliar with link on thi forum :
http://neweopencascade.wordpress.com/2014/03/25/building-a-pipe-elbow/
Wed, 03/26/2014 - 12:07
Dear Sebastien
It was very useful, thanks. I want to draw a pipe elbow with wall thickness. Do you have any idea?
Wed, 03/26/2014 - 14:46
Well I was about to propose you to use a TopoDS_Face as a profile, but it seems it's not supported. Maybe I'm wrong I need to have a closer look or someone confirm us it can't work.
By the way une can build 2 pipe surfaces and close the solid creating 2 flat faces using this exemple : http://neweopencascade.wordpress.com/2014/03/01/post1/
Wed, 03/26/2014 - 15:06
Here is a way to achieve what you describe, maybe it's not the best way and any suggestions are welcome.
http://neweopencascade.wordpress.com/2014/03/26/building-a-thick-pipe-el...
Wed, 04/02/2014 - 17:15
Hi Mohammand,
I think you can use BRepPrimAPI_MakeThickSolid to have a try.
You can also use a bigger Elbow to cut a smaller elbow. :-)
Best Regards,
Xing