Wed, 07/26/2000 - 14:42
Forums:
Hello,
For creating sweep solid i am using the following constructor,
BRepOffsetAPI_MakePipe(const TopoDS_Wire& Spine,
const TopoDS_Shape& Profile);
But the problem is that i am not able to get the Face on one side of the solid. Please note that i am passing closed curves in profile.
I experienced similar problem while creating the solid prism by using the following constructor.
BRepPrimAPI_MakePrism(TopoDS_Face, vector);
But i got the solution by passing boolean varaible i,e
BRepPrimAPI_MakePrism(TopoDS_Face, vector , Standard_True);
But the same is not working in case of sweep solid.
Kindly suggest ways / ideas in this regards.
With advanced Thanks,
Venkata Krishna
Fri, 07/28/2000 - 14:28
I swept a circle along a line (to get a cylinder). Investigations showed that the new circular edge formed at the farther end of the cylinder is a degenerated edge. No face was created there. Please help me in sorting out this problem.
With Regards,
Venkata Krishna